Tuesday, February 07, 2012

Beechcraft C35, N8974A: Plane In Crash May Have Made Emergency Landing. Accident occurred August 04, 2010 in Rollinsville, Colorado


DENVER (AP) — Investigators say a plane involved in a crash that killed three people in Colorado appears to have made an emergency landing days earlier because of a propeller issue.

A National Transportation Safety Board report issued last week quotes the daughter of one of the passengers as saying the pilot made the emergency landing because of a wiring problem in the propeller governor, which limits the speed of the propeller.

The single-engine plane crashed Aug. 4 in the mountains near Rollinsville, killing everyone aboard.

Authorities identified the victims as the 70-year-old pilot, John Howard of Sunnyvale, Calif., and his passengers, 56-year-old Catherine Heveran of Sunnyvale and 25-year-old James Chatham of Spokane, Wash.

The plane took off from Boulder en route to San Jose, Calif.

The NTSB has not determined the cause.

NTSB Identification: CEN10FA458
14 CFR Part 91: General Aviation
Accident occurred Wednesday, August 04, 2010 in Rollinsville, CO
Aircraft: BEECH C35, registration: N8974A
Injuries: 3 Fatal.

HISTORY OF FLIGHT

On August 4, 2010, about 0620 mountain daylight time, a Beechcraft C35 airplane, N8974A, impacted trees and terrain in the Roosevelt National Forest near Rollinsville, Colorado. The commercial pilot and the two passengers were fatally injured. The personal flight was being conducted under the provisions of 14 Code of Federal Regulations Part 91 without a flight plan. Visual meteorological conditions prevailed at the time of the accident. The cross-country flight departed Boulder Municipal Airport (BDU), Boulder, Colorado, at 0600 and was en route to Norman Y. Mineta San Jose International Airport (SJC), San Jose, California.

No comments:

Post a Comment