Tuesday, January 30, 2018

Bell OH-58C, N942SC, operated by the Spalding County Sheriff's Department: Accident occurred January 29, 2018 in Zebulon, Pike County, Georgia

The National Transportation Safety Board did not travel to the scene of this accident.

Additional Participating Entities: 

Federal Aviation Administration / Flight Standards District Office; Atlanta, Georgia
Rolls-Royce; Indianapolis, Indiana 

Aviation Accident Factual Report - National Transportation Safety Board: https://app.ntsb.gov/pdf

Investigation Docket - National Transportation Safety Board: https://dms.ntsb.gov/pubdms

Location: Zebulon, GA
Accident Number: ERA18LA075
Date & Time: 01/29/2018, 1725 EST
Registration: N942SC
Aircraft: BELL OH 58C
Aircraft Damage: Substantial
Defining Event: Loss of engine power (partial)
Injuries: 2 None
Flight Conducted Under: Public Aircraft

On January 29, 2018, about 1725 eastern standard time, a Bell OH-58C, N942SC, operated by the Spalding County Sheriff's Department, was substantially damaged during a hard landing after a loss of engine power near Zebulon, Georgia. The certificated flight instructor and the student pilot were not injured. Visual meteorological conditions prevailed, and no flight plan was filed for the local public use instructional flight.

In written statement and a telephone interview, the instructor stated the purpose of the flight was to provide flight training to a sheriff's department detective. He said that the accident occurred at the completion of the 5th simulated engine failure of the flight. When the throttle was advanced for the power recovery, the engine accelerated and the engine and rotor tachometer needles "joined" in the normal operating range of the dual engine/rotor tachometer.

Once normal operating rpm was achieved for the engine and rotor, the instructor initiated a climb. Approximately "4 to 5 seconds" into the climb, and about 25 knots and 125 feet above ground level, there was a "loss of power from the engine." The instructor stated he checked the throttle position and crossed checked the dual tachometer. He said the engine rpm had decayed to 70 percent, and he reduced collective pitch to maintain rotor rpm. He then cycled the throttle to idle and back to full open, but sensed no corresponding response from the engine.

The instructor selected a field and completed the forced landing. He said that due to "low rotor rpm" he performed an aggressive flare to build rpm and cushion the landing. The tail of one skid along with the tail stinger struck the ground and the main rotor contacted the tailboom before the helicopter came to rest upright.

The instructor held a commercial pilot certificate with ratings for airplane single engine land, rotorcraft-helicopter, as well as instrument airplane and helicopter. He held a flight instructor certificate with the same ratings. His most recent Federal Aviation Administration (FAA) third-class medical certificate was issued March 22, 2016. The pilot estimated he had 5,800 total hours of flight experience of which 200 hours were in the OH-58C.

The helicopter was manufactured in 1968 for the United States Army and was acquired by the Spalding County Sheriff's Department for public use. It was maintained under an annual inspection program. The most recent annual inspection was completed July 14, 2017 at 8,596 total aircraft hours and had accrued 56.9 hours since that date.

At 1755, the weather reported at Griffin-Spalding County Airport (6A2), 6 miles northeast of the accident site included clear skies, 10 miles visibility, and winds from 350 degrees at 8 knots gusting to 19 knots. The temperature was 14° C, the dewpoint was -7° C, and the altimeter setting was 30.08 inches of mercury.

The wreckage was examined at the accident site by an FAA inspector and all major components were accounted for at the scene. Examination of photographs revealed substantial damage to the tailboom near the fuselage (buckling) and evidence of a strike to the tail rotor driveshaft cover. Continuity of flight and engine controls was confirmed by an airframe and powerplant mechanic. The helicopter was retained for further examination.

Detailed examination of the helicopter confirmed proper throttle continuity and rigging. The throttle position was measured at the fuel control across a 90-degree arc. Idle cut-off was 0-5 degrees, ground idle was 30 degrees, and 90 degrees was full throttle. The governor came out of "lock-out" at 39 degrees, but full fuel flow was not available until the throttle was fully open at 90 degrees. The engine was then removed for operational testing.

Fuel system continuity and boost-pump pressurization of the system was confirmed, with no leaks noted.

The engine was placed in a test cell where it started immediately, accelerated smoothly, and ran continuously without interruption through the entire test protocol prescribed by the manufacturer.

The engine successfully completed ground idle, flight-idle, max-continuous-power, and take-off power runs. When corrected for standard atmospheric conditions, the engine yielded performance 6.3% above new-production standards at "low cruise? (300 horsepower), 4.9% above new-production standards at normal cruise (370 horsepower), and 10.5% above new-production standards at maximum (Take-Off) power (420 horsepower). The engine then completed "wave-off" max-power transients where the power was reduced to flight idle and then rapidly increased to take-off power. The engine responded normally and responded with maximum power without surging or hesitation.

Pilot Information

Certificate: Flight Instructor
Age: 70, Male
Airplane Rating(s): Single-engine Land
Seat Occupied: Left
Other Aircraft Rating(s): Helicopter
Restraint Used: 4-point
Instrument Rating(s): Airplane; Helicopter
Second Pilot Present: Yes
Instructor Rating(s): Airplane Single-engine; Helicopter
Toxicology Performed: No
Medical Certification: Class 3 With Waivers/Limitations
Last FAA Medical Exam: 03/22/2016
Occupational Pilot: No
Last Flight Review or Equivalent:
Flight Time:  5800 hours (Total, all aircraft), 200 hours (Total, this make and model) 

Aircraft and Owner/Operator Information

Aircraft Make: BELL
Registration: N942SC
Model/Series: OH 58C NO SERIES
Aircraft Category: Helicopter
Year of Manufacture: 1968
Amateur Built: No
Airworthiness Certificate:
Serial Number: 68-16872
Landing Gear Type: Skid;
Seats: 4
Date/Type of Last Inspection: 07/14/2017, Annual
Certified Max Gross Wt.:
Time Since Last Inspection: 57 Hours
Engines: 1 Turbo Shaft
Airframe Total Time: 8596.3 Hours as of last inspection
Engine Manufacturer: Rolls Royce
ELT: Not installed
Engine Model/Series: T63-A-700
Rated Power: 317 hp
Operating Certificate(s) Held: None 

Meteorological Information and Flight Plan

Conditions at Accident Site: Visual Conditions
Condition of Light: Day
Observation Facility, Elevation: K6A2, 959 ft msl
Distance from Accident Site: 6 Nautical Miles
Observation Time: 2155 UTC
Direction from Accident Site: 23°
Lowest Cloud Condition: Clear
Visibility:  10 Miles
Lowest Ceiling:None 
Visibility (RVR):
Wind Speed/Gusts: 8 knots / 19 knots
Turbulence Type Forecast/Actual: /
Wind Direction: 350°
Turbulence Severity Forecast/Actual: / Unknown
Altimeter Setting: 30.08 inches Hg
Temperature/Dew Point: 14°C / -7°C
Precipitation and Obscuration: No Obscuration; No Precipitation
Departure Point: GRIFFIN, GA (6A2)
Type of Flight Plan Filed: None
Destination: GRIFFIN, GA (6A2)
Type of Clearance: None
Departure Time: 1600 EST
Type of Airspace: Class G

Wreckage and Impact Information

Crew Injuries: 2 None
Aircraft Damage: Substantial
Passenger Injuries: N/A
Aircraft Fire: None
Ground Injuries: N/A
Aircraft Explosion: None
Total Injuries: 2 None

Latitude, Longitude:  33.134444, -84.321111 (est)

No comments: