14 CFR Part 91: General Aviation
Accident occurred Friday, May 24, 2013 in Cross Timbers, MO
Probable Cause Approval Date: 02/10/2014
Aircraft: ROBINSON HELICOPTER COMPANY R44 II, registration: N569BC
Injuries: 2 Fatal.
NTSB investigators either traveled in support of this investigation or conducted a significant amount of investigative work without any travel, and used data obtained from various sources to prepare this aircraft accident report.
The helicopter pilot was conducting an aerial tour. After the helicopter did not return when it was expected, a search was conducted. The wreckage was located the following day in a sparsely populated and densely wooded area. Signs of impact damage were found on nearby trees. A postimpact fire had consumed the fuselage and most of the empennage. A postaccident examination of the airframe revealed no evidence of mechanical malfunctions or failures that would have precluded normal operation. A power line was found wrapped around the main rotor drive shaft, and a section of the power line was found resting on the ground leading from the power line pole toward the main wreckage. Before impact, the power line was perpendicular to the helicopter flightpath and suspended about 65 feet above the ground. It is likely that the pilot did not see and avoid the power line and that the helicopter impacted the power line and, subsequently, trees and terrain.
The National Transportation Safety Board determines the probable cause(s) of this accident as follows:
The pilot's failure to see and avoid a power line during the low-altitude flight.
HISTORY OF FLIGHT
On May 24, 2013, about 1800 central daylight time, a Robinson R44 II helicopter, N569BC, collided with a powerline near Cross Timbers, Missouri. The commercial pilot and passenger were fatally injured and the helicopter was destroyed. The helicopter was registered to and operated by Lucas Oil Products, Inc. under the provisions of 14 Code of Federal Regulations Part 91 as a corporate flight. Visual meteorological conditions prevailed for the flight and no flight plan was filed. The flight originated from Lucas Oil Speedway, Wheatland, Missouri, about 1730.
According to information provided by the Federal Aviation Administration (FAA) and the pilot's landing zone marshal, the helicopter took off from the speedway to provide an aerial tour for the passenger and did not return when it was expected. A local search was conducted about 2100 to locate the helicopter. The wreckage was discovered from the air about 0130 on the following day in a densely wooded area.
According to a witness near the accident scene, he observed the helicopter flying overhead and then appeared to land in a field nearby. He stated that as the helicopter was flying overhead, the engine did not sounds normal. However, he is not familiar with helicopter engines and their sounds. Moments later, the helicopter appeared to have lifted off from the ground and then level off. He did not notice anything out of the ordinary at that time.
PERSONNEL INFORMATION
The pilot, age 32, held a commercial pilot certificate for airplane single engine land, airplane multi engine land, rotorcraft helicopter, and airplane instrument. He also held a flight instructor certificate for helicopter and flight instructor for instrument helicopter. He was issued a second class medical certificate issued on June 5, 2012.
A review of the pilot's logbooks revealed that as of May 19, 2013, he accumulated 1,983.5 total flight hours. Of the 1,983.5 hours, 1,054.5 hours were in the make and model of the accident helicopter, 1,041.4 of which he served as pilot in command. He accumulated 918.8 flight hours in the accident helicopter.
According to the pilot's ground marshal, when asked about the pilot's flying habits, he reported the pilot liked to be at least 500 feet above any clouds and no lower than 300 feet above ground level when the clouds were not a factor. The pilot would fly at cruise speeds so the passengers could take pictures.
AIRCRAFT INFORMATION
The four-seat, single main rotor, single-engine helicopter, serial number 11349, was constructed primarily of metal, and manufactured in 2006. The helicopter was powered by a 260-horsepower Lycoming IO-540-AE1A5 engine, serial number L-31379-48A, and with a maximum continuous rating of 245-horsepower.
The helicopter was maintained on an annual inspection plan as well as a 100-hour inspection plan. A review of the helicopter's maintenance logbooks revealed that a 100-hour inspection was completed on the airframe and engine on March 13, 2013, at a total time of 1,219.6 hours.
METEOROLOGICAL INFORMATION
The automated weather report from Camdenton Memorial Airport (KH21), which was about 30 miles east of the accident site, reported at 1755: wind 110 degrees at 7 knots, 10 miles visibility, clear skies, temperature 72 degrees Fahrenheit (F), dewpoint 41 degrees F, and a barometric pressure of 30.24 inches of Mercury.
WRECKAGE AND IMPACT INFORMATION
A postaccident on-scene examination of the helicopter was conducted on May 26, 2013, by the National Transportation Safety Board (NTSB) Investigator-in-Charge (IIC), inspectors from the FAA, and a technical representative from the airframe manufacturer. The helicopter came to rest in a sparsely populated and densely wooded area of rolling terrain about 7 miles northeast of the Lucas Oil Speedway. A postimpact fire consumed the fuselage and most of the tail boom. The main rotor, tail rotor, and tail rotor gear box separated from the helicopter during the accident sequence.
The helicopter came to rest in an upright position on a northerly heading. There were signs of impact damage on the nearby trees and the rotor blades, windscreen, and metal fragments were scattered across the wreckage path. The main wreckage and surrounding area received thermal damage. The forward cabin was positioned where the second tree was located; it was mostly consumed by fire and impact damage was evident. The aft cabin area was positioned just behind the tree and was mostly consumed by fire. The area from the vertical firewall to halfway through the tail boom was also consumed by fire. The second half of the tail boom, which contained the registration number decal, received impact and thermal damage.
A powerline, which exhibited impact damage, was found wrapped around the main rotor and a section of the powerline was found on the ground leading from the powerline pole to the main wreckage. The origin of the powerline was traced back to a powerline pole which would have suspended the line about 65 feet above the ground.
Flight control continuity could not be established due to impact and thermal damage, but flight control fractures were consistent with overload and thermal damage. All of the associated hardware and rod ends remained attached respectively. All flight control connections were accounted for and secure.
Rotational scoring was evident between the fixed and rotating swash plate. The main rotor blades were fractured in multiple places and were labeled A and B for identification purposes only. The spar of blade A was separated about 18" from the hub assembly. The spar from blade B was separated about 24" from the hub assembly. Beyond the initial points of separation, the remaining portion of each spar was intact and sustained impact damage. The leading edges of the blades exhibited chord-wise striations in a chatter pattern that was consistent with contacting the metal powerline.
The tail rotor blades were both separated at the root fittings and received impact damage. The tail rotor blades were labeled A and B for identification purposes only. Blade A was fractured the root fitting and blade B was fractured in multiple places. Both blades exhibited leading edge impact damage.
There was no evidence of abnormal wear or damage on either the upper or lower sheave grooves. The upper sheave exhibited rotational scoring around the entire aft face. The sprag clutch assembly in the upper sheave still operated as designed. Continuity was confirmed from the clutch shaft to the forward flex coupling assembly which was still connected to the main rotor transmission input. The main rotor gear box was fractured in overload just above the case connecting point. The mast and the upper half of the case came to rest beside the main wreckage. The remaining main rotor transmission case was melted. Continuity was confirmed from the main rotor ring gear to the main rotor drive shaft. The hub assembly remained attached and continuity was confirmed at the connection point.
The entire instrument panel was detached from the cockpit and was found near the main wreckage. The panel sustained impact damage. The ignition switch was found in the left magneto position. The flight instruments provided no useful information. The filaments for each warning light were examined and none of them exhibited stretching that would have indicated they were illuminated at the time of impact.
The engine received impact and thermal damage. The bottom of the case melted and the crankshaft was clearly visible. The accessories were melted away from the case. Cylinders 1-3-5 were separated from the case. Cylinders 2-4-6 remained attached to the case.
The helicopter was retro-fitted with main and auxiliary bladder fuel tanks. Fuel quantity stickers specific to the bladder tanks were placed on the instrument panel. The bladder tanks received thermal damage and only the caps were recovered. Bladder material was evident around the aluminum fitting on the underside of the tank. The smell of aviation gas was evident underneath the area where the tanks were located.
MEDICAL AND PATHOLOGICAL INFORMATION
An autopsy was performed on the pilot on May 28, 2013, by Southwest Missouri Forensics, Springfield, Missouri. The autopsy reported the cause of death as cerebral anoxia secondary to hypoxemia due to aspiration of blood induced by blunt force trauma to the head and chest.
The FAA Civil Aerospace Medical Institute prepared a Final Forensic Toxicology Fatal Accident Report. The results were negative for all screened substances.
14 CFR Part 91: General Aviation
Accident occurred Friday, May 24, 2013 in Cross Tmbers, MO
Aircraft: ROBINSON HELICOPTER COMPANY R44 II, registration: N569BC
Injuries: 2 Fatal.
This is preliminary information, subject to change, and may contain errors. Any errors in this report will be corrected when the final report has been completed. NTSB investigators either traveled in support of this investigation or conducted a significant amount of investigative work without any travel, and used data obtained from various sources to prepare this aircraft accident report.
On May 24, 2013, about 1800 central daylight time, a Robinson R44 II helicopter, impacted trees and terrain near Cross Timbers, Missouri. The commercial pilot and passenger were fatally injured and the helicopter was destroyed. The helicopter was registered to and operated by Lucas Oil Products, Inc. under the provisions of 14 Code of Federal Regulations Part 91 as a business flight. Visual meteorological conditions prevailed and no flight plan was filed. The flight originated from Lucas Oil Speedway, Wheatland, Missouri, about 1730.
According to information provided by the Federal Aviation Administration (FAA) the helicopter departed from the speedway to provide an aerial tour for the passenger. The helicopter did not return when expected and a local search was initiated about 2100. The wreckage was discovered from the air, about 0130 on the following day in a densely wooded area.
A postaccident on-scene examination of the helicopter was conducted on May 26, 2013, by the National Transportation Safety Board (NTSB) Investigator-in-Charge (IIC), FAA inspectors, and a technical representative from the helicopter manufacturer. The helicopter came to rest upright in a densely wooded area of rolling terrain about 7 miles northeast of the speedway. A postimpact fire consumed the fuselage and most of the empennage. The main rotor and tail rotor separated from the helicopter.
The impact point and wreckage path were consistent with the helicopter’s westerly flight path over a tree line. A wire, which was originally suspended in the air about 65 feet above the ground, was found wrapped around the main rotor and laying in the woods up to where the main wreckage was located.
Flight control continuity was established for the anti-torque pedals, collective and cyclic. The rotors exhibited signs of rotation.
A Garmin global positioning system (GPS) 500 and a Lowrance Elite-5m Chartplotter were located at the accident site and were retained for further examination.
http://registry.faa.gov/N569BC
Sunday, May 26, 2013: UPDATE -- The Hickory County Coroner has officially released the names of the two people killed in a helicopter crash near Cross Timbers on Friday.
The pilot was 32 year-old William Higgenbotham from Arizona and 21 year-old Catalina Richard from Bolivar.
The National Transportation Safety Board is expected to arrived at the crash site sometime today.
Catalina Richard
The Highway Patrol says two people died in a helicopter crash in Hickory County near Cross Timbers.
Kelly Richard is the older sister to of one of the victims. She says Catalina Richard was a passenger in the helicopter. She was a student at Missouri State and just started working for Lucas Oil, which owned the chopper.
Kelly Richard says her sister and the pilot were supposed to fly around at the company's speedway in Wheatland. Something went wrong and they wound up way off course.
Official word on the victim's names and what caused the crash hasn't been released by federal investigators.
The family has set up a Facebook page for details about the funeral.
Source: http://www.ktts.com
The Missouri State Highway Patrol says it was two people that died in a helicopter crash in Hickory County near Cross Timbers.
Kelly Richard is the older sister to of one of the victims. She says it was Catalina Richard who was in that helicopter. Richard was a student at Missouri State and worked for Lucas Oil who also owned the chopper.
Richard says her sister and the pilot were only to fly around an event put on by Lucas Oil. When the two didn't return after a half hour, people on the ground alerted authorities
The official word from the National Transportation Safety Board on the victim's names and the cause hasn't been released. Troopers say the crash is in a heavily wooded area.
The Highway Patrol says Federal Aviation Administration and National Transportation Safety Board officials are expected to arrive sometime tomorrow.
