14 CFR Part 91: General Aviation
Accident occurred Friday, July 20, 2012 in Corona, CA
Aircraft: CESSNA 182P, registration: N640AM
Injuries: 2 Serious.
This is preliminary information, subject to change, and may contain errors. Any errors in this report will be corrected when the final report has been completed.
On July 20, 2012, about 1815 Pacific daylight time, a Cessna 182P, N640AM, collided with power lines during a forced landing following a loss of engine power near Corona, California. The pilot was operating the airplane under the provisions of 14 Code of Federal Regulations Part 91, as an aerial observation flight. The certificated commercial pilot and passenger sustained serious injuries. The airplane sustained substantial damage during the accident sequence, and was subsequently consumed by post impact fire. The local flight departed Riverside Municipal Airport, Riverside, California, about 1800, with a planned destination of Corona Municipal Airport. Visual meteorological conditions prevailed, and no flight plan had been filed.
The pilot reported that he was a traffic reporter, and the flight was a traffic-watch mission for a local radio station. They initially departed from Corona at 1450, and for the next 3 hours, the flight proceeded uneventfully. While returning to Corona, the engine speed dropped twice from 2,200 to approximately 1,000 rpm, and as such, the pilot elected to land at Riverside as a precaution. After landing, he taxied to the departure end of the runway, and performed an engine run-up, which included cycling the propeller, checking the carburetor heat, and both magnetos. All checks were normal, and he was unable to replicate the problem. After discussing the anomaly with his passenger, he elected to proceed to Corona.
The departure and climbout were normal, and after about 5 minutes, the engine speed again began to oscillate, followed by a loss of power sufficient to prevent the airplane from maintaining altitude. The pilot began troubleshooting procedures, and having deduced that he would not be able to reach Corona Airport, prepared for a forced landing. As the descent progressed, and they passed over a housing development, he realized he would not be able to reach his intended landing point. He subsequently turned the airplane towards a field adjacent to the houses. During the final approach, the airplane struck a set of power lines, and collided with the ground.
The airplane came to rest on a heading of 280 degrees magnetic, at the end of a dirt field, about 6,500 feet east of the arrival end of runway 25. Fire consumed the entire cabin from the empennage, through to the firewall, along with the inboard wing sections. The engine sustained minimal damage, and was recovered with the airframe remnants for further examination.
FAA IDENTIFICATION
Regis#: 640AM Make/Model: C182 Description: 182, Skylane
Date: 07/21/2012 Time: 0122
Event Type: Accident Highest Injury: None Mid Air: N Missing: N
Damage: Substantial
LOCATION
City: CHINO State: CA Country: US
DESCRIPTION
AIRCRAFT CRASHED UNDER UNKNOWN CIRCUMSTANCES. CHINO, CA
INJURY DATA Total Fatal: 0
# Crew: 0 Fat: 0 Ser: 0 Min: 0 Unk: 1
# Pass: 0 Fat: 0 Ser: 0 Min: 0 Unk: 1
# Grnd: Fat: 0 Ser: 0 Min: 0 Unk:
OTHER DATA
Activity: Unknown Phase: Unknown Operation: OTHER
FAA FSDO: RIVERSIDE, CA (WP21) Entry date: 07/23/2012
http://registry.faa.gov/aircraftinquiry/NNum_Results.aspx?NNumbertxt=640AM
No comments:
Post a Comment