14 CFR Part 91: General Aviation
Accident occurred Thursday, February 09, 2012 in Morgan, UT
Probable Cause Approval Date: 04/10/2013
Aircraft: CESSNA 210, registration: N9619T
Injuries: 2 Fatal.
NTSB investigators either traveled in support of this investigation or conducted a significant amount of investigative work without any travel, and used data obtained from various sources to prepare this aircraft accident report.
During a volunteer flight to pick up a passenger, the non-instrument-rated pilot had to divert to an alternate airport due to low ceilings at his destination. After picking up the passenger and departing, the pilot requested and received a flight-following clearance. Shortly thereafter, he reported that he was going to turn the airplane out of a valley. There was no further communication from the pilot after this transmission. The last radar target depicted the airplane at an elevation of 7,100 feet. The wreckage was located 3.5 miles from the last radar target in treed, mountainous terrain at an elevation of 7,700 feet. A postaccident examination of the wreckage revealed no evidence of mechanical malfunctions or failures that would have precluded normal operation. Weather information current at the time of the flight reported mountain obscuration and precipitation. Review of weather briefing data showed no record of the pilot obtaining a weather briefing prior to departure. Given the forecast and reported weather conditions, it is likely that the pilot encountered instrument meteorological conditions and was unable to see the trees and terrain prior to the collision.
The National Transportation Safety Board determines the probable cause(s) of this accident to be:
The non-instrument-rated pilot’s poor planning and continued visual flight rules flight into instrument meteorological conditions and failure to maintain clearance from mountainous terrain.
HISTORY OF FLIGHT
On February 9, 2012, about 1348 mountain standard time, N9619T, a Cessna 210, collided with mountainous terrain about 9 miles east-northeast of Morgan County Airport, Morgan, Utah. The private pilot and passenger sustained fatal injuries during the 14 Code of Federal Regulations Part 91 flight. The airplane was substantially damaged. The flight originated from Morgan and was destined for Converse County Airport, Douglas, Wyoming. The pilot requested and received a flight following clearance.
The pilot was conducting a mission for the Wyoming Pilots for Christ. He was volunteering his services to transport the passenger, a nurse, from the Salt Lake City area back to her home. According to Wyoming Pilots for Christ personnel, the pilot had departed Douglas about 1000 MST and intended to land at Salt Lake City International Airport, Salt Lake City, Utah. However, the pilot landed in Morgan due to low ceilings in the area. The passenger then met him at the Morgan airport.
PILOT INFORMATION
The pilot, age 47, held a private pilot certificate with airplane and single-engine land ratings. He held a third-class medical certificate issued September 27, 2011, with no limitations or waivers. The pilot’s logbook was reviewed and showed about 553 total flight hours. He had flown about 18 hours in the last 90 days and 10 hours in the last 30 days.
AIRPLANE INFORMATION
The high wing airplane, SN 57419, had four seats and retractable gear. It was manufactured in 1961. It was powered by a Continental IO-470-E (17) engine. Review of the maintenance records showed an annual inspection was completed on February 10, 2011, at a total time of 3,465 hours. The airplane was equipped with a Garmin 430.
AIR TRAFFIC CONTROL INFORMATION
An NTSB air traffic control specialist reviewed the air traffic control information pertaining to the flight, as well as the pilot’s flight earlier that day from Sheridan, Wyoming, to Morgan, Utah.
Review of the radar track of the pilot’s inbound flight from Sheridan showed radar targets along the mountain range to the east of the pilot’s landing airport. The radar targets showed several course reversals along the mountain range. The track then ended prior to the pilot’s landing in Morgan, likely due to limited radar coverage in the area.
Upon departure from Morgan, the pilot requested and received a flight following clearance at 1346 MST, and advised that his destination was Douglas. Shortly thereafter, the pilot reported that he was going to turn the airplane out of a valley. There was no further communication from the pilot. The last radar target was at 1448 at an altitude of 7,100 feet, approximately 3.5 statute miles from the accident site.
METEOROLOGICAL INFORMATION
An NTSB senior meteorologist completed a weather study. A composite of the NWS Weather Depiction Charts for 1200 (1900Z) and 1500 MST (2200Z) on February 9, 2012, depicted a small area of reported instrument flight rule (IFR) conditions over Idaho immediately north of the accident site at 1200 MST by a shaded contour, with another area over Colorado to the east-southeast. The areas were enclosed by a larger area of marginal visual flight rule (MVFR) conditions by an unshaded contour which extended over northern Utah and the accident site.
At 1355, an aviation routine weather report (METAR) for Hill Air Force Base, located about 17 nautical miles west-southwest of the accident site, reported the following conditions: wind, calm, visibility, 7 statute miles, clouds, few at 2,700 feet, overcast at 3,200 feet, temperature, 3 degrees Centigrade, dew point, 0 degrees Centigrade, altimeter, 30.33 inches of mercury. The subsequent observations indicated a ceiling overcast from 2,100 to 2,600 feet agl or from 6,900 to 7,400 feet msl assuming normal rounding to a hundred feet, and with a period of visibility reduced to 5 miles in mist. The cloud heights would have implied a high likelihood of mountain obscuration conditions over the accident site.
At the accident airplanes altitude of 7,700 feet the sounding indicated a temperature of -3º C, a temperature-dew point temperature spread of less than 1 degree C, a relative humidity of 98 percent, and a wind from 275 degrees at 9 knots. The sounding did not indicate a high probability of turbulence due to the light winds and low vertical shear. A probability of icing existed in clouds and in precipitation above 6,000 feet.
The GOES-15 infrared band 4 satellite image at 4X magnification for 1415 MST (2215Z) on February 9, 2012, depicted multiple layers of low to mid-level clouds over Utah during the period. No defined cumulonimbus clouds or thunderstorms were identified over the area. The infrared image indicated a radiative cloud top temperature over the accident site at 260 degrees kelvin or -13.16 degrees C, which corresponded to tops near 14,500 feet over the accident site.
The GOES-15 visible band 1 image at 1415 MST (2115Z) depicted low stratiform clouds over the area with a second mid-level band of altostratus bordering on the accident site. The image indicates a high probability of mountain obscuration with the low stratiform type clouds over the region.
The forecast for northern Utah indicated scattered to broken clouds at 10,000 feet layered to 17,000 feet were expected over the region. The forecast however was amended by AIRMET Sierra update 6 for mountain obscuration due to clouds and precipitation issued at the same period.
Review of weather briefing data from Lockheed Martin Flight Service, CSC DUATS, and DTC DUATS, showed no record of the pilot obtaining a weather briefing.
WRECKAGE AND IMPACT INFORMATION
Initial responders reported that the airplane impacted a northwest-facing, treed slope, at an elevation of approximately 7,700 feet mean sea level. The debris field was approximately 75 feet in length and on a general heading of west-northwest.
MEDICAL AND PATHOLOGICAL INFORMATION
The Utah Office of the Medical Examiner performed an autopsy on the pilot on February 11, 2012. The manner of death was reported as an accident due to injuries as a result of the accident.
The FAA Bioaeronautical Science Research Laboratory, Oklahoma City, Oklahoma, completed forensic toxicology on specimens from the pilot. The report was negative for volatiles, cyanide, and tested drugs. The report stated 10 percent carbon monoxide was detected in the blood. Cotinine and nicotine were also detected.
TESTS AND RESEARCH
An NTSB investigator, the FAA accident coordinator, and a representative from Cessna Aircraft Company examined the wreckage. Examination of the recovered airframe revealed that it was separated into numerous pieces. The right wing was separated from the fuselage and exhibited crushing damage along the entire span of the leading edge. The right wing lift strut remained attached to the forward spar and a fragmented portion of the fuselage frame. The right flap was in the retracted position. The flap actuator measured 0.15 inches which equated to a retracted position. The aileron remained attached to its respective hinge points. Aileron control cable continuity was established to the wing root. The separations of the control cables at the wing root were consistent with cuts made by recovery personnel. The fuel bladder was fragmented. The fuel cap was secure; however the structure surrounding the fuel cap was separated from the wing.
The left wing was separated from the fuselage. The left wing lift strut was separated from the wing and fuselage. The aileron was separated from the wing structure. The flap assembly remained attached to the inboard portion of the left wing. The fuel bladder was fractured. The fuel cap remained attached to the upper wing surface and was in place. The outboard portion of the left wing was not recovered (recovery personnel reported it was in a 70-foot tall tree).
The aft portion of the fuselage was separated from the forward portion of the fuselage. The vertical stabilizer and rudder remained attached to their respective mounts. The inboard sections of the horizontal stabilizers remained attached. The elevators were separated from their mounts. The right elevator was fragmented and the trim tab was separated. The elevator trim actuator was fragmented which prevented measurement of the actuator. Flight control cable continuity was established from the elevator and rudder control horns forward to the cuts made by recovery personnel.
Control cable continuity was established from the cockpit controls to the area of cuts made by wreckage recovery personnel. Continuity for aileron controls was obtained throughout the aileron control chain to the left and right wing root. The seats and seat tracks were fragmented and separated from the fuselage. The pilot side seat engagement pin was found engaged to a separated portion of seat track.
The airspeed indicator was found separated and the airspeed needle was observed stuck at 180 knots. The altimeter setting was observed at 30.22. Both doors were separated from the fuselage. The pitot-static system was fragmented. The unobstructed pitot tube was intact and separated from the wing structure.
Examination of the Teledyne Continental Motors (TCM) IO-470-E (17) engine, serial number 088778-R, revealed that all six cylinders remained attached to the engine crankcase. All engine accessories remained attached to the engine with the exception of the starter, which was separated from its mount. The exhaust, propeller, and oil filler cap were separated. The oil sump was crushed upwards. The top spark plugs, rocker arm covers, fuel pump, oil pump, left and right magnetos, and throttle body fuel control were removed. The engine crankshaft was rotated by hand using a hand tool attached to an accessory mount pad. Rotational continuity was established throughout the engine and valve train. Thumb compression and suction was obtained on all six cylinders. Both magnetos produced sparks at all posts when manually rotated. The top spark plugs were examined and found to be consistent with worn out normal when compared to the Champion Check-A-Plug comparison card. Light gray coloring was noted within the electrode areas. Examination of the fuel system revealed no contamination or anomalies. The vacuum pump drive shaft rotated freely by hand. The vacuum pump was disassembled and the rotor and vanes were intact and undamaged.
The propeller was separated from the engine crankshaft propeller flange. Both propeller blades exhibited aft bending and blade twisting and remained attached to the propeller hub. Both propeller blades exhibited multi directional scratching on the forward face of the blade.
No evidence of pre-impact mechanical malfunction was noted during the examination of the recovered wreckage.
ORGANIZATIONAL AND MANAGEMENT INFORMATION
According to the Pilots for Christ website, “Pilots for Christ International, Inc. is a membership organization that posts public requests, for consideration by our member pilot's and non-pilot's regarding volunteer urgent travel opportunities. The decision to accept and provide travel assistance, by yourself is an individual matter between yourself and the person(s), requesting travel. Pilots for Christ International, Inc. offers communication, (contact, urgency of request and indemnity waiver) assistance, only, between the requester and yourself as a pilot or non-pilot. You must always abide by all Federal, State and local legal requirements for operating your aircraft, and/or automobile. The requirement to meet these licensed operating regulations is strictly your responsibility, and is not the responsibility of Pilots for Christ International, Inc. As a pilot or non-pilot you are not required to be a commercial or professional individual and you are not required to meet the same standards. You are a private individual volunteering your aircraft, and/or automobile and time to help all those in need of urgent transportation, within the scope of your licensed abilities.”
ADDITIONAL INFORMATION
The Aircraft Owners and Pilots Association has an online course designed to assist volunteer pilots. The course “Public Benefit Flying: Balancing Safety and Compassion”, can be found at www.airsafetyinstitute.org/volunteerpilots.
Pilots for Christ, Daleray Madewell, mans the controls of his 1960 Cessna as he flies from Douglas to Casper on Oct. 10 to pick up Heather Street for a charity flight to the Mayo Clinic in Rochester, Minn. Madewell was killed Thursday in a plane crash in Morgan County, Utah, along with Jennifer Sebesta of Glenrock, according to a story Friday by the Douglas Budget.
Daleray Madewell and Jeniffer Sebesta
Douglas pilot and business owner Daleray Madewell and his passenger, Jennifer Sebesta of Glenrock, were killed Thursday in the Wasatch Mountains near Morgan County, Utah, when their plane crashed while flying a mission for Wyoming Pilots for Christ, according to the Douglas Budget.
National Transportation Safety Board spokesman Peter Knudson said three people were killed in the crash. An investigator is expected to arrive Saturday.
Madewell was meeting Sebesta in Salt Lake City to bring her back to Douglas but was forced to land short of the city because of bad weather on Thursday, according to a story on the newspaper’s website Friday.
Sebesta later met Madewell in Morgan County, where the two left for Wyoming. About 20 minutes after takeoff, around 2 p.m., Madewell radioed the tower in Morgan County and advised them he was turning back because of bad weather.
Shortly thereafter, radar and airport personnel lost contact with the aircraft.
Around 7 p.m., after Madewell failed to check in, emergency crews were dispatched via snowmobile to the area where the plane was believed to have gone down.
Responders hiked 12 miles up the mountain on snowshoes before poor weather forced them to retreat until morning.
When day broke Friday, a helicopter took off in search of the plane and found it wrecked in a steep canyon about nine miles northeast of the airport. When crews reached the wreckage, no survivors were found.
Madewell, owner of Double D Liquors in Douglas, was well known for his generosity and flew around 20 flights for Pilots for Christ.
He left behind five children and long-time girlfriend Denise Murphy.
Sebesta, a registered nurse at Memorial Hospital of Converse County, left behind three children.
