NTSB Identification: CEN13CA007
14 CFR Part 91: General Aviation
Accident occurred Tuesday, October 02, 2012 in Eden Prairie, MN
Probable Cause Approval Date: 12/19/2012
Aircraft: CIRRUS DESIGN CORP SR20, registration: N750SR
Injuries: 1 Uninjured.
NTSB investigators used data provided by various entities, including, but not limited to, the Federal Aviation Administration and/or the operator and did not travel in support of this investigation to prepare this aircraft accident report.
The pilot reported that he flew a visual approach and landed near the midpoint of a 2,691-foot-long runway. The wind was at 5 knots and aligned with the runway, which was dry. After landing, the pilot applied “light/normal braking” but noticed his deceleration rate was inadequate to stop on the remaining runway. The pilot subsequently applied heavier braking, but the brakes “seemed to have no effect.” Realizing he was not going to stop the airplane on the remaining runway, the pilot attempted a go-around near the departure end of the runway. The airplane never became airborne, departed the runway, and impacted an airport perimeter fence. Substantial damage to the airplane included impact damage to both wings and ailerons. Skid marks from the accident airplane were documented near the departure end of the runway. A postaccident examination of the braking system of the airplane revealed no mechanical malfunctions that would have precluded normal operation.
The National Transportation Safety Board determines the probable cause(s) of this accident to be:
The pilot’s inadequate braking action and decision to abort the landing near the departure end of the runway. Contributing to the accident was the pilot’s attempt to land near the midpoint of the runway.
The pilot reported that he flew a visual approach and landed near the midpoint of a 2,691 foot runway. The wind was at 5 knots and aligned with the runway, which was dry. After landing, the pilot applied “light/normal braking”, but noticed his deceleration rate was inadequate to stop on the remaining runway. The pilot subsequently applied heavier braking, but the brakes “seemed to have no effect.” Realizing he was not going to stop the airplane on the remaining runway, the pilot attempted a go-around near the departure end of the runway. The airplane never became airborne, departed the runway, and impacted an airport perimeter fence. Substantial damage to the airplane included impact damage to both wings and ailerons. A post-accident examination conducted by Federal Aviation Administration (FAA) personnel documented skid marks from the accident airplane near the departure end of the runway. FAA personnel also conducted a post-accident examination of the braking system of the airplane, with no abnormal findings.
NTSB Identification: CEN13CA007
14 CFR Part 91: General Aviation
Accident occurred Tuesday, October 02, 2012 in Eden Prairie, MN
Aircraft: CIRRUS DESIGN CORP SR20, registration: N750SR
Injuries: 1 Uninjured.
NTSB investigators used data provided by various entities, including, but not limited to, the Federal Aviation Administration and/or the operator and did not travel in support of this investigation to prepare this aircraft accident report.
The pilot reported that he flew a visual approach and landed near the midpoint of a 2,691 foot runway. The wind was at 5 knots and aligned with the runway, which was dry. After landing, the pilot applied “light/normal braking”, but noticed his deceleration rate was inadequate to stop on the remaining runway. The pilot subsequently applied heavier braking, but the brakes “seemed to have no effect.” Realizing he was not going to stop the airplane on the remaining runway, the pilot attempted a go-around near the departure end of the runway. The airplane never became airborne, departed the runway, and impacted an airport perimeter fence. Substantial damage to the airplane included impact damage to both wings and ailerons. A post-accident examination conducted by Federal Aviation Administration (FAA) personnel documented skid marks from the accident airplane near the departure end of the runway. FAA personnel also conducted a post-accident examination of the braking system of the airplane, with no abnormal findings.
IDENTIFICATION Regis#: 750SR Make/Model: SR20 Description: SR-20 Date: 10/02/2012 Time: 2340 Event Type: Incident Highest Injury: None Mid Air: N Missing: N Damage: Unknown LOCATION City: EDEN PRAIRIE State: MN Country: US DESCRIPTION AIRCRAFT WENT OFF THE RUNWAY AND INTO THE FENCE, EDEN PRAIRE, MN INJURY DATA Total Fatal: 0 # Crew: 1 Fat: 0 Ser: 0 Min: 0 Unk: # Pass: 0 Fat: 0 Ser: 0 Min: 0 Unk: # Grnd: Fat: 0 Ser: 0 Min: 0 Unk: OTHER DATA Activity: Unknown Phase: Unknown Operation: OTHER FAA FSDO: MINNEAPOLIS, MN (GL15) Entry date: 10/04/2012
KMSP-TV
http://www.myfoxtwincities.com
EDEN PRAIRIE, Minn. (KMSP) - Part of Flying Cloud Drive is closed after a plane went off the runway at the Flying Cloud airport on Tuesday night.
The highway is expected to remain closed between Pioneer Trail and the airport until about 10 p.m.
Officials say a fixed wing, single-engine Cirrus SR20 aircraft was landing when it went through a fence. Investigators are still trying to determine what went wrong.
The pilot was the only person on board at the time, and he said he simply could not stop the plane. No injuries have been reported.
FlightAware.com, which provides live flight tracking online, reported that the plane took off from Des Moines International at 4:23 p.m. on Tuesday Afternoon and was supposed to land at the Airlake Airport in Lakeville at 5:49 p.m. It is unclear if the plane made that stop.
FAA investigators are on the scene.
http://www.myfoxtwincities.com